Siemens SIPROTEC 4 7UT6 Series - Page 329

Device Module for Jumper
Quiescent State
open (close)
Quiescent State
closed (open)
Presetting
7UT635 Slot 5 right BO1 X40 1-2 2-3 1-2
Slot 33 left BO9 X40 1-2 2-3 1-2
Slot 19 left BO1
7
X40 1-2 2-3 1-2
The pickup voltages of the binary inputs BI6 through BI29 are checked according to the following table:
Table 3-13 Jumper settings of the Pickup Voltages of the binary inputs BI6 through BI29 on the input/
output board C-I/O-1 or C-I/O-10
Binary inputs Jumpers on
C-I/O-1 and
C-I/O-10
Jumpers on
C-I/O-10 up
release EE or
higher
Threshold
19 V
2
)
Threshold
88 V
3
)
Threshold
176 V
4
)
Slot 33 left
Slot 19 left
1
) Slot 5 right
1
)
BI14 BI22 BI6 X21/X22 X21 L M H
BI15 BI23 BI7 X23/X24 X23 L M H
BI16 BI24 BI8 X25/X26 X25 L M H
BI17 BI25 BI9 X27/X28 X27 L M H
BI18 BI26 BI10 X29/X30 X29 L M H
BI19 BI27 BI11 X31/X32 X31 L M H
BI20 BI28 BI12 X33/X34 X33 L M H
BI21 BI29 BI13 X35/X36 X35 L M H
1)
Only for C-I/O-1
2)
Factory settings for devices with power supply voltages DC 24 to 125 V
3)
Factory settings for devices with power supply voltages DC 110 to 250 V and AC 115 V
4)
Factory settings for devices with power supply voltages DC 220 to 250 V and AC 115
The jumpers X71 through X73 serve for setting the bus address. Their position may not be changed. The
following tables list the jumper presettings.
Table 3-14
Jumper settings of the Module Addresses of the input/output boards C-I/O-1 and C-I/O-10
Jumper Mounting Location
Slot 19 left Slot 33 left Slot 5 right
X71 H L H
X72 H H L
X73 H H H
Input/Output Board C-I/O-2 (only 7UT613 and 7UT633)
The input/output board C-I/O-2 is available only in 7UT613 and 7UT633. Mounting location: for 7UT613 slot
19, for 7UT633 slot 19 right side
Mounting and Commissioning
3.1 Mounting and Connections
SIPROTEC 4, 7UT6x, Manual 329
C53000-G1176-C230-5, Edition 09.2016