Siemens siprotec 7SA6 User Manual

Control During Operation
7-397SA6 Manual
C53000-G1176-C133-1
From the
Device Front
With a device ready for operation, first press the key. The 0$,10(18 appears.
Using the key, highlight the menu item 7HVW'LDJQRVH, and then press the
key to enter sub-menu. 7(67',$*126( will appear at the top of the menu.
At this point, highlight the menu item 7HVW(QDEOH using the key, and then press
the key to enter sub-menu. 7(67(1$%/( will appear at the top of the menu. See
Figure 7-38.
Figure 7-38 Applying Test Mode from the Operator Control Panel
To start 7HVWPRGH, press the key, enter the password N° 4 (for test and
diagnostics) and confirm with the key. A new window appears with the options
21 and 2)). Use the and keys to select the desired mode, and press the
key. The question “$UH\RXVXUH"” is displayed. Highlight the desired response and
press the key. If the mode is changed, the footer shows the message “&RQWURO
([HFXWHG” for a short time.
Use the key to return to the 7(6 7',$*126( level; press the key to return to
the 0$,1 0(18.
The procedure for changing the Block Data Transmission mode is the same. See
Figure 7-39 (simplified).
Figure 7-39 Applying a Block of Data Transmission from the Front Panel (simplified)
The settings for the test mode and the data transmission block are normally 2)).
Definitions:
− 7HVWPRGH – With the 21 setting, the “test mode”-bit is transferred for messages
compatible with IEC 60 870–5–103.
− 'DWD6WRS – With the 21 setting, no messages or measured values are
transferred (“transfer block”).
From PC with
DIGSI
®
4
Click on 'HYLFH in the menu bar to reach the commands %ORFN'DWD
7UDQVPLVVLRQ and 7HVW0RGH. See Figure 7-40.
MENU
7(67(1$%/(

!7HVWPRGH2))

7(67',$*126(

'HYLFH5HVHW²!
!7HVW(QDEOH²!
%ON'DWD7UDQV²!
+DUGZDUH7HVW²!
6HW5HVHW²!
6,(0(16,QWHUQ
ENTER
ENTER
ENTER
ENTER
MENU
7(67',$*126(

!%ON'DWD7UDQV²!
+DUGZDUH7HVW²!
%/.'$7$75$16

!'DWD6WRS2))

:

Siemens siprotec 7SA6 Specifications

General

Brand	Siemens
Model	siprotec 7SA6
Category	Relays
Language	English