Wi-Fi Connection / Troubleshooting Add Network Advanced (Connecting to a hidden network)
128
2. To connect, select your network from the available networks (Figure 14-2).
Figure 14-2
A password is required when choosing a secured (protected) network.
Networks with a proxy, challenge page, or that require the user to accept terms
of usage are not supported.
Wi-Fi performance varies depending on your wireless network equipment and
ISP.
3. Enter the required password and press Next, or select Connect to continue.
4. Select OK to connect, or Forget to cancel.
– The Snap-on Cloud registration information is displayed. For Snap-on Cloud
registration information see Snap-on Cloud on page 13.
– If “Not Connected” is displayed, try to reconnect or see “Wi-Fi Testing” on
page 129 for additional information.
14.3 Add Network Advanced (Connecting
to a hidden network)
The Add Network selection allows you to connect to a network that is not
broadcasting its name (not visible in the displayed network list). These networks are
also known as "hidden" networks.
To connect to a hidden network you will first need to know the following:
• Network Security Type
– Open (only need SSID)
– WPA or WPA2 (Pre-shared key)
– Note - WEP encryption is NOT supported
• Network name or SSID (Service Set Identifier)
• Network Password
Home Screen: Tools > Settings > Configure Wi-Fi
1. To connect, select Add Network Advanced from the available network list.
2. Select security type Open, WPA, or WPA2. Refer to the router user manual or
your IT administrator to determine the type.
3. Enter the network name or SSID
4. Enter the network password and press Next.
5. Select OK to connect.
To Next Page
Loading...
Need help?
General
