Sony MVS-8000X System - Settings for the Wipe Snapshot Menu

Chapter 19 Control Panel Setup (Panel)
1007
Operation Settings (Operation Menu)
For details of the operation, see “Setting the group number of an S-Bus
description name” (page 1102).
1 In the <Source/Dest Name> group of the Panel >Operation menu, select
the names to be used from the following.
Sw’er Local: Source names set in the Xpt Assign menu, and fixed bus
names
S-Bus Descript: Description names set in the router
S-Bus Type + Num: Type + Num set in the router (In this case always
eight characters.)
2 In the <Name Display Mode> group, select the method of display in the
source name displays.
Auto: Optimize display according to number of characters. A name of up
to two characters appears as two characters in one line. A name of up
to four characters appears as four characters in one line.
Otherwise, up to the first eight characters are shown in two lines.
2 Character: The first two characters appear.
4 Character: The first four characters appear.
To replace a name set in the Xpt Assign menu with an S-Bus
description name
Turn [S-Bus Name Link] on.
This has such effect that each time a description name is changed on the router,
the corresponding source name is automatically changed. Thus, the same
description name can always be used both on the router and the switcher.
Even when [Sw’er Local] is selected, the same name as when [S-Bus Descript]
is selected can be displayed. The S-Bus description name can also be displayed
in the Xpt Assign menu.
Settings for the Wipe Snapshot Menu
You can select the pattern numbers or register names as the button indications
for the following menus.
• M/E-1 >Wipe >Wipe Snapshot menu
• M/E-1 >DME Wipe >DME Wipe Snapshot menu
• Misc >Snapshot menu
1 In the Panel >Operation menu, press [Flexi Pad Mode].
The Flexi Pad Mode menu appears.
The status area shows a list of the items with their settings.