Chapter 6 DME Wipes
273
Basic Procedure for DME Wipe Settings
Basic Procedure for DME Wipe Settings
You carry out DME wipe setting operations principally using the DME Wipe
menu for each bank.
This section describes the basic procedures for DME wipe settings, taking the
M/E-1 >DME Wipe menu as an example.
For details of independent key transition DME wipe settings, see “DME Wipe
Settings for Independent Key Transitions” (page 284).
For details of resizer DME wipe, see page 288.
DME Wipe Settings Menu
Accessing the DME Wipe menu
To access the M/E-1 >DME Wipe menu, use either of the following operations.
• In the menu control block, select the top menu selection button [M/E 1], and
press VF6 ‘DME Wipe.’
Notes
To select [M/E-4], a previous assignment in the Setup menu is required.
• In the transition control block of the M/E-1 bank, press the transition type
selection button [DME] twice in rapid succession.
Either of the above operations displays the M/E-1 >DME Wipe menu.
DME Wipe Pattern Selection
Selecting a DME wipe pattern by a menu operation
1
In the M/E-1 >DME Wipe menu, select HF1 ‘1ch’ for one-channel mode,
HF2 ‘2ch’ for two-channel mode or HF3 ‘3ch’ for three-channel mode.
2
Select the desired DME wipe pattern group with one of the following
buttons.
• Slide/Squeeze: slide and squeeze
• Split/Door: split and door
To Next Page
Loading...
