Chapter 19 Control Panel Setup (Panel)
957
Overall Control Panel Settings (Config Menu)
To assign a key to the main base
To assign a key to the independent key transition control block (simple type),
use the following procedure. Here the example shown is the case in which keys
3 and 4 (“Key3,4”) are assigned to the second row switcher bank of the main
base.
1
In the Panel >Config menu, press [Compact Key Module Assign].
The Compact Key Module Assign menu appears.
The left side of the status area shows data for the main base (physical
layout and switcher bank names and key assignment).
2
Press directly on the display on the left, to select the control block for the
assignment.
Here, press on the intersection of the “2nd Row” column and “Module”
row.
3
Select the key from the table on the right.
4
Press [Set].
To return the key assignment to the default
In the Compact Key Module Assign menu, press [Default].
This returns all key assignments for the main base to their factory default state.
To assign a key to an extension
Press [Extension Port], to display the Extension Port menu, then continue as for
the main base.
To return the extension assignments to their original values, press [Default].
Assigning Functions to Key Control Block Buttons
Select one of the four key control blocks installed in the main base and
extension, then assign functions to the 30 buttons.
1
In the Panel >Config menu, press [Link/Program Button].
The Link/Program Button menu appears.
2
Press [Key Control Module].
The Key Control Module menu appears.
To Next Page
Loading...
