Chapter 2 Menus and Control Panel
65
Names and Functions of Parts of the Control Panel
“Memory Stick”/USB Connections Block
a “Memory Stick” status indicator
Lights in red during access to a “Memory
Stick.”
Notes
Do not power the unit off or remove a
“Memory Stick” when the “Memory Stick”
status indicator is lit.
b “Memory Stick” slot
Insert “Memory Sticks.” You can use it in
software installation, and for saving and
reading data, such as snapshot, keyframe,
effect, and setup data.
See the next item, “Memory Sticks” for
more information about the usable
“Memory Sticks” and their handling.
c DEVICE connectors
There is a USB connector.
You can connect a device such as a mouse,
keyboard, USB storage, and so on, that is
equipped with a USB interface to any of
these connectors.
For details on the devices that can be
connected, consult your Sony
representative.
d POWER A, B status indicators
The status indicators light in green when
the unit is powered on.
The POWER B status indicator does not
light when the optional HK-PSU11 Power
Supply Unit is not supplied in the factory
configuration.
About “Memory Sticks”
Usable “Memory Sticks”
This unit has been confirmed to operate
with those of the following “Memory
Sticks” that have a capacity of 8 GB
(gigabytes) or less. However, operation
with all “Memory Sticks” is not guaranteed.
• “Memory Stick”
• “Memory Stick PRO”
• “Memory Stick Duo”
• “Memory Stick PRO Duo”
Notes
• When using a “Memory Stick PRO,”
high-rate data transfer using parallel
interface is not supported.
• A “MagicGate Memory Stick” can also
be used, but this system does not support
the MagicGate function.
• When using a “Memory Stick Duo,” be
sure to use it with a “Memory Stick Duo
3 DEVICE connector
2 “Memory Stick” slot
1 “Memory Stick” status indicator
4 POWER A, B status indicators
To Next Page
Loading...
