Sony MVS-8000X System - Switching the Input Reference Signal for HD System

Chapter 18 System Setup (System)
909
Setting the Signal Format (Format Menu)
• Turn the knob.
2 Press [Signal Format].
A pop-up window appears.
3 Press the button for the desired signal format.
Switching the Input Reference Signal for HD System
This changes the input reference signal.
• Tri Sync: tri-level sync for an HD system
• BB (Black Burst): black burst or sync
The following table shows the relation between signal format and the
frequency of a signal that can be used as the input reference signal.
Knob Parameter Adjustment Setting values
1 Device Selection of device for operations 1 and upwards
Signal format Input reference signal
Tri Sync Black burst
1080PsF/29.97
1080P/59.94,
1080i/59.94
59.94 Black Burst 59.94 Sync 59.94
1080PsF/25
1080P/50, 1080i/50
50 Black Burst 50 Sync 50
1080PsF/23.976 47.952
Black Burst 59.94
a)
Sync 59.94
a)
1080PsF/24 48 –
720P/59.94 59.94 Black Burst 59.94 Sync 59.94
720P/50 – Black Burst 50 Sync 50