Chapter 13 Keyframe Effects
710
Creating and Editing Keyframes
Insertion
Inserting keyframes
To insert a keyframe in an existing effect, use the following procedure in the
keyframe control block.
1
Press the [EDIT ENBL] button, turning it on.
2
Stop the effect at the desired edit point.
3
Create the image for the keyframe you want to insert.
4
Press the [INS] button.
When the edit point is on a keyframe, to insert the new keyframe before
the existing keyframe, hold down the [SHIFT] button and press the [INS]
button.
This inserts the current image as the new keyframe.
Inserting a keyframe may change the total duration of the effect. (See
“Time Settings” (page 686).)
Modification
Modifying keyframes
Use the following procedure in the keyframe control block.
1
Press the [EDIT ENBL] button, turning it on.
2
Stop the effect at the desired edit point.
When the edit point is on a keyframe, this is what you modify. If the edit
point is between two keyframes, the previous keyframe is what you
modify.
Notes
In constant duration mode (see page 686) modification is only possible
when the edit point is on a keyframe.
3
Using image transformations or adding special effects, modify the
keyframe.
To Next Page
Loading...
