Chapter 11 DME Operations
514
DME Special Effect Operations
4
To set the key border color, press [Flat Color] and adjust the following
parameters.
To select an outline only key
Press [Outline], turning it on.
The outline only effect is enabled.
Art Edge Settings
Notes
The Art Edge function is not supported on the MVE-8000A.
Applying art edges
1
In the DME menu, select VF1 ‘Edge’ and HF4 ‘Art Edge.’
The Art Edge menu appears.
2
Press [Art Edge], turning it on.
This enables art edges, and you can now use the knobs to adjust the
parameters.
Notes
The Defocus, Blur, Key Border, and Glow effects cannot be applied to the
Art Edge sections.
Knob Parameter Adjustment Setting values
1 H Simultaneously adjust width of left
and right key borders
0.00 to 100.00
2 V Simultaneously adjust width of top
and bottom key borders
0.00 to 100.00
3 All Simultaneously adjust width of all
four key borders
Value of H shown
4 Soft Softness of the key borders 0.00 to 100.00
5 Density Density of the key borders 0.00 to 100.00
Knob Parameter Adjustment Setting values
1 Luminance Luminance 0.00 to 100.00
2 Saturation Saturation 0.00 to 100.00
3 Hue Hue 359.99 to 0.00
To Next Page
Loading...
