Chapter 4 Keys
214
Resizer
• To shrink, magnify, or move the key, turn on the [LOC XYZ(LOC)].
Hold these buttons down while carrying out the operation of step 5 to
enable fine adjustment (fine mode).
5
Use the trackball for the operation.
For details of parameters, see step 3 of “Key control block (MKS-8035
Key Control Module, option) operations for key shrinking, magnification
and movement” (page 212).
Entering parameters
This operation is the same as DME three-dimensional parameter input.
For details, see “Entering Three-Dimensional Parameter Values” in Chapter
11 (Volume 2).
Resetting parameters
This operation is the same as DME three-dimensional parameter resetting.
For details, see “Entering Three-Dimensional Parameter Values” in Chapter
11 (Volume 2).
Clearing resizer effects
To clear two-dimensional transform parameters only and set the
initial state
In the device control block, press the [CLR WORK BUFR] button in the
operation buttons.
To clear all resizer parameters, and set the initial state
In the device control block, press the [CLR WORK BUFR] button in the
operation buttons, twice in rapid succession.
For the initial state, you can select either the factory default settings or user
settings.
For details of how to make this selection, see “Selecting the State After
Powering On (Start Up Menu)” in Chapter 18 (Volume 3).
Resizer Interpolation Settings
For example, to make the interpolation settings for key 1 of the M/E-1 bank,
use the following procedure.
To Next Page
Loading...
