Chapter 11 DME Operations
637
Global Effect Operations
Shadow Settings
The effect uses two successive channels. You can adjust the position and
density of the shadow with respect to the image, and the color of the shadow.
The channel with the largest number (for example, Ch2 in the case of Ch1 and
Ch2) becomes the shadow.
Notes
When the Combiner function is off, the shadow effect cannot be used.
Applying the Drop Shadow effect
The Shadow menu allows you to apply the Drop Shadow effect. To access the
Shadow menu, in the Global Effect>Ch1 - Ch4 menu select HF3 ‘Shadow.’
Depending on the selected combiner channels, the valid buttons differ as
follows.
Taking Ch1 Shadow as an example, the following explains the procedure for
applying the Drop Shadow effect.
1
Press [Ch1 Shadow], turning it on.
The Drop Shadow effect is enabled, and channel 2 becomes the channel for
the shadow to the image. You can adjust the position and density of the
shadow with the knobs.
Notes
The flex shadow function cannot be enabled when Drop Shadow is
enabled.
However, the flex shadow function is not supported on the MVE-8000A.
2
Set the parameters.
Combiner channel
selection
Button
Ch1
Shadow
Ch2
Shadow
Ch3
Shadow
Ch1+Ch2
Shadow
Ch2+Ch3
Shadow
Ch1+Ch2 Valid
Ch2+Ch3 Valid
Ch3+Ch4 Valid
Ch1+Ch2+Ch3 Valid Valid Valid
Ch2+Ch3+Ch4 Valid Valid Valid
Ch1+Ch2+Ch3+Ch4 Valid Valid Valid Valid
To Next Page
Loading...
