Chapter 14 Snapshots
761
Snapshot Operations in the Menus
2
Press the region display in the upper part of the list to display a selection
window, then select the region in the selection window. Selecting multiple
regions is also possible.
3
Press [OK].
The selected region name appears in the upper part of the list.
4
Using any of the following methods, select the register.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
5
In the <Recall Mode> group, select one of the following modes for save
and recall operations.
XPT: Only the key material selection data is saved or recalled.
Modifier: Only the key modifier settings are saved or recalled.
Transition: Only the independent key transition settings are saved or
recalled.
Creating and Saving a Master Snapshot
To save a master snapshot in the Snapshot menu, after recalling the Snapshot
>Master Snapshot >Store menu, refer to the operations in “Creating and
Saving a Master Timeline With the Menu” (page 735).
Recalling the Store menu
1
Do either of the following.
• In the menu control block, press the top menu selection button
[SNAPSHOT].
• In the numeric keypad control block, press the [SNAPSHOT] button
twice in rapid succession.
The Snapshot menu appears.
2
Press VF1 ‘Master Snapshot’ and HF1 ‘Store.’
The Master Snapshot >Store menu appears.
Knob Parameter Adjustment Setting values
1 Register Register number 1 to 4
To Next Page
Loading...
