Chapter 16 Macros
818
Macro Attachment Assigning
Removing macro attachment settings
To cancel a macro attachment to a button
Hold down the [PRE MCRO] or [POST MCRO] button assigned to a utility/
shotbox control block button or user preference button, and press the
background A row button that is flashing. The button for which a macro
attachment was set stops flashing and goes off, and the setting is canceled.
To cancel a macro attachment to a fader lever
Hold down the [PRE MCRO] or [POST MCRO] button assigned to a utility/
shotbox control block or user preference button, and press the [LIMIT SET] or
[PRIOR SET] button in the control block containing the fader lever having the
macro attachment set.
To remove all macro attachment settings in a single operation
You can remove all macro attachment settings in a single operation.
1
In the Macro menu, select VF2 ‘Attachment.’
2
Press [All Clear].
A confirmation message appears.
3
Select [Yes].
This deletes all macro attachment setting data.
Displaying the Macro Attachment List
In the Macro >Attachment menu, you can display the macro attachment list to
check the macro attachment settings.
The macro attachment list includes the following columns.
• Block: Shows the names of control panel blocks.
• Button: Shows the names of macro attachment assigned buttons (of up to 30
characters).
• Reg: Shows the names of assigned registers.
• Name: Shows the names of macro registers.
• Mode: Shows the names of macro modes (Pre/Post/Only/---
1)
).
Above the list is shown the names of the block and macro attachment assigned
button currently selected in the list.
1) When no macro mode is set
To Next Page
Loading...
