Chapter 15 Utility/Shotbox
781
Shotbox Register Editing
Shotbox Register Editing
You can carry out the following editing on shotbox registers.
• Lock: Write-protect the contents of the register.
• Copy: Copy data from one register to another.
• Move: Move data from one register to another.
• Swap: Swap the contents of two registers.
• Delete: Delete the contents of a register.
• Name: Attach a name to a register.
The procedures for shotbox register editing are similar to the procedures
described in “Effect Register Editing” (page 739).
Unlike in effect register editing, however, it is not necessary to specify a region
in shotbox register editing.
To Next Page
Loading...
