Chapter 19 Control Panel Setup (Panel)
943
Overall Control Panel Settings (Config Menu)
• Program Button: Make assignments for buttons of some control blocks
such as assigning the buttons in a transition control block for controlling a
VTR.
• Compact Key Module Assign: You can select which keys can be operated
with an independent key transition control block (simple type).
• M/E Operation Inhibit: For each M/E or PGM/PST bank, enable or inhibit
utility 2 bus-related and key-related operations.
• Joystick/Trackball Module: Enable or inhibit DME channel selection
operations from the device control block (trackball) or device control block
(joystick).
Interchanging the Bank Order or Disabling Operation
1
In the Panel >Config menu, select the Bank you want to set, using any of
the following methods.
• Press directly on the status area display.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
The Bank selection here indicates the physical position on the control
panel, numbering from the top as the 1st Row, 2nd Row, 3rd Row, and 4th
Row.
On the MKS-9011 1M/E Control Panel only the 1st Row is valid. On the
MKS-9012 2M/E Control Panel, only the 1st Row and 2nd Row are valid.
2
Select the bank that you want to assign to the selected Bank number in the
<M/E Assign> group.
The status area shows the interchanged state of the banks.
Notes
• It is not possible to assign the same M/E logical bank to more than one
physical bank. Be sure to make different M/E assignments.
• When the bank order is changed, the state of region selection button
assignment in the numeric keypad control block also changes
correspondingly.
3
For the selected Bank number, in the <M/E Operation> group, select one
of the following.
Enable: Enable panel display and operation of the bank.
Knob Parameter Adjustment Setting values
1 Bank Select the position of the bank you want
to set
1 to 7
To Next Page
Loading...
