Chapter 11 DME Operations
620
DME Special Effect Operations
• When executing combining four channels of DME images, “Mix Color”
and “Ext Video” cannot be selected.
2
Only if Flat Color is selected in step 1, adjust the following parameters.
Separate Sides Settings
Applies separate video signals and key signals to the front and back of the
image.
Applying the Separate Sides effect
1
In the DME menu, select VF6 ‘Input/Output’ and HF2 ‘Video/Key.’
The Video/Key menu appears.
2
Press [Separate Side], turning it on.
The Separate Sides effect is enabled. If the video and key signals currently
being output to the monitor are the front side, you can select the front
signals. If they are the back side, you can select the back signals. Video and
key signals are selected with the cross-point control blocks of each M/E
bank or the PGM/PST bank.
Invert Settings
Inverts the input video signal and/or key signal horizontally or vertically. You
can make separate settings for the front and back.
Applying the Invert effect
1
In the DME menu, select VF6 ‘Input/Output’ and HF2 ‘Video/Key.’
The Video/Key menu appears.
Knob Parameter Adjustment Setting values
1 Luminance Luminance 0.00 to 100.00
2 Saturation Saturation 0.00 to 100.00
3 Hue Hue 359.99 to 0.00
To Next Page
Loading...
