Chapter 18 System Setup (System)
932
System Maintenance (Maintenance Menu)
System Maintenance (Maintenance Menu)
• Date and time setting
• Formatting a memory card
• Primary settings for USB external storage device
• Reloading a USB driver
• Formatting the hard disk
• Locking setup menu operations
– For each VF button group, selecting a set of candidate menus to be locked,
then locking all of the candidates using a password. Except for list
scrolling, moving menus, and similar operations, menu operations for all
settings can be locked.
– Changing the password
• Locking file recall operations
– Locking file recall operations by category
– Locking and removing the lock using the password (You can change the
password.)
To display the Maintenance menu
In the Engineering Setup menu, select VF1 ‘System’ and HF7 ‘Maintenance.’
In the status area, the current date and time, and details of the memory card
appear.
Setting the Date and Time
For system date and time settings, use the following procedure.
1
In the System >Maintenance menu, turn the knobs to set the following
parameters.
Parameter group [1/2]
Parameter group [2/2]
Knob Parameter Adjustment Setting values
1 Hour Hour 0 to 23
2 Min Minute 0 to 59
3 Sec Second 0 to 59
Knob Parameter Adjustment Setting values
1 Month Month 1 to 12
2 Day Day 1 to 31
To Next Page
Loading...
