Chapter 11 DME Operations
537
DME Special Effect Operations
Blur Settings
Applying the Blur effect
1
In the DME menu, select VF2 ‘Video Modify’ and HF1 ‘Defocus/Blur.’
The Defocus/Blur menu appears.
2
Press [Blur], turning it on.
The Blur effect is enabled. You can adjust the blurring of video and key
signals with the knobs.
Notes
On the MVE-8000A, the Glow and Blur effects cannot be enabled at the
same time. The effect which was turned on most recently is enabled.
3
Set the parameters.
Masking the Blur effect with a selected pattern
Press [Mask] to display the Mask menu, and set the pattern type and modifiers.
For details, see “Mask Settings” (page 548).
Multi Move Settings
Applying the Multi Move effect
1
In the DME menu, select VF2 ‘Video Modify’ and HF2 ‘Multi Move.’
The Multi Move menu appears.
2
Press [Multi Move], turning it on.
Knob Parameter Adjustment Setting values
1 H Horizontal defocusing of video
and key signals
0.00 to 100.00
2 V Vertical defocusing of video and
key signals
0.00 to 100.00
3 All Horizontal and vertical
defocusing of video and key
signals
H value shown
To Next Page
Loading...
