Chapter 2 Menus and Control Panel
50
Names and Functions of Parts of the Control Panel
Cross-Point Control Block
In the cross-point control block, you can
select the signals to be used in this M/E
bank or PGM/PST bank.
a Cross-point buttons
These buttons select the signals used for
video creation on this M/E bank or PGM/
PST bank. Each row of buttons corresponds
to one or more signal buses within the
switcher.
Key row: The buttons in this row select the
bus signals specified with the key row
delegation buttons ([DSK1] to [DSK8],
[DME1] to [DME4], [UTIL1], or
[UTIL2]) or delegation buttons in the
auxiliary bus control block.
The later pressed delegation button
takes precedence and the selection is
reflected in the key row.
For details of DSK5 to DSK8
assignment, see “Assigning Buttons for
Selection of Keys 5 to 8 in the Setup
Menu” (page 459) in Appendix
(Volume 1).
Background A row: Press the desired
button to select the signal as the current
1 Cross-point buttons
2 Source name displays
3 Key row delegation buttons
4 XPT HOLD button
5 SHIFT button
Key row
Background A row
Background B row
To Next Page
Loading...
