Chapter 2 Menus and Control Panel
64
Names and Functions of Parts of the Control Panel
Menu Control Block
a Top menu selection buttons
These select the menu appearing in the
menu display.
It is also possible to change the assignment
of these buttons in setup.
For details, see “Overall Control Panel
Settings (Config Menu)” in Chapter 19
(Volume 3).
b Menu display
This shows the menu currently in use.
c Knobs
These adjust the parameter values
appearing in the menu.
d User preference buttons
These recall the functions or menus
assigned to them in the Setup menu.
In the default setup, nothing is assigned to
the [PREFS 1] to [PREFS 7] buttons.
It is also possible to change the assignment
of these buttons in setup.
For details, see “Overall Control Panel
Settings (Config Menu)” in Chapter 19
(Volume 3).
PREFS 8 button: When this button is on,
control of an editor from the Remote1
port on the rear panel of the switcher is
possible. However, even when it is off,
control of the Edit PVW bus is always
possible.
2 Menu display1 Top menu selection buttons
3 Knobs4 User preference buttons
To Next Page
Loading...
