Chapter 19 Control Panel Setup (Panel)
955
Overall Control Panel Settings (Config Menu)
1
In the Panel >Config >Link/Program Button menu, press [DSK/FTB
Module].
The DSK/FTB Module menu appears.
The left side of the status area shows the DSK1 and DSK2 buttons, and the
right side shows a list of keys to be assigned.
2
Press the indication (DSK1, DSK2) of the button for the assignment.
The button you pressed changes to reverse video.
3
Using any of the following methods, select the key to be assigned.
• Press directly on the list.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
4
Press [Set], to confirm the selection.
This assigns the selected key to the key delegation button.
To return the key delegation button assignment to the factory
default state
In the DSK/FTB Module menu, press [Default].
This returns the key delegation assignment to the factory default state.
Assigning Keys to the Independent Key Transition
Control Block (Simple Type)
It is possible to select the keys that can be used in an independent key transition
control block (simple type) operation.
Notes
This operation cannot be done in the CCP-9000A.
The control panel comprises a main base for installing the principal switcher
bank control blocks, and an extension section for extended control blocks. The
independent key transition control block (simple type) can be installed in
either, but the assignable keys differ as follows.
Knob Parameter Adjustment Setting values
1 Key No Selection of key assigned to
button
1 to 40
To Next Page
Loading...
