Chapter 1 MVS-8000X Functions
37
Basic Video Processing
Copy and Swap
This function can be used to copy and swap the settings among the M/E-1 to
M/E-3, and PGM/PST banks or between keyers.
The following settings can be copied or swapped.
• Overall settings for the M/E and PGM/PST banks
• Keyer settings
• Wipe settings in a transition control block
• Wipe settings in an independent key transition control block
• DME wipe settings in a transition control block
• DME wipe settings in an independent key transition control block
• Matte color settings (color 1, color 2, and how to compose them)
• Color settings
• DME channel settings
• Format converter input settings (copy only)
• Format converter output settings (copy only)
For details, see “Copy and Swap” (page 352).
Video Process
The term “video process” is applied to adjustments to the gain, hue, black level
of the input video signal. There are two types of adjustment; adjustment of an
individual input signal and adjustment as image effects on a particular bus.
For details, see “Video Process” (page 368).
Color Corrector
The color corrector enables video signal color correction (black balance/white
balance adjustment, gamma correction, knee correction, etc.).
The color corrector includes the following adjustments.
• Input video processing
• Primary color correction
• Secondary color correction
• Luminance processing
• Spot color adjustment
• Output video processing
• YUV/RGB clip
For details, see Chapter 9 “Color Corrector” (page 371).
To Next Page
Loading...
