Chapter 13 Keyframe Effects
717
Creating and Editing Keyframes
Keyframe Loop (Repeated Execution of a Specified
Range)
By setting the range of the loop within the effect, and the number of loop
executions, you can execute the loop range repeatedly.
Notes
It is only possible to set one keyframe loop for each region.
Creating a new keyframe loop
To specify the loop range and loop count, carry out the following procedure.
1
Press the [EDIT ENBL] button, turning it on.
2
Stop the effect on the keyframe you want to make the first of the loop range
(start point). (Here, by way of example, keyframe 2 is taken as the start
point.)
3
Press the [KF LOOP] button in the keyframe control block, turning it on.
The numeric keypad control block display shows the start point keyframe
number as follows.
The example shown means “from (keyframe) 2 to...,” where the end
keyframe is to follow.
4
With the numeric keypad buttons of the numeric keypad control block,
enter the number of the last keyframe in the loop range (end point). (Here,
by way of example, keyframe 5 is the end point.)
5
Press the [ENTER] button to confirm the entry.
The display changes as follows, prompting you to enter the loop count.
6
Enter the loop count. (Here, by way of example, “15” is entered.)
• To specify a loop count, enter a number in the range 1 to 99.
• To specify an endless loop, enter “0” (zero).
FM 2 TO
FM 2 TO 5
COUNT
To Next Page
Loading...
