Chapter 10 Special Functions
403
Multi Program 2
Examples of Operations in the Multi Program 2 Mode
(When Sharing a Switcher Bank)
To create video on the M/E or PGM/PST bank assigned to both main and sub
operations, use the following procedure.
1
Press the [MAIN] button, turning it on, and turning off the [SUB] button.
2
With the normal operations, create the main video.
3
Press the [SUB] button, turning it on, and turning off the [MAIN] button.
Now you can create the sub video.
4
Create the sub video.
The basic method of operation is the same as for the main video, except
that the utility 2 bus signal is assigned to background A, and the utility 3
bus signal is assigned to background B.
For sub, only keys 2 to 8 can be used, and for wipes, standard wipe patterns
only. There are also other differences in operation from standard mode.
For details, see “Differences Between Multi Program 2 Mode and
Standard Mode” (page 408) and “Restrictions on Using Multi Program 2
Mode” (page 409).
5
Press the [MAIN] and [SUB] buttons simultaneously, turning them on.
If both buttons are lit, the control panel shows the status of main.
6
Carry out the transition.
Both main and sub video images are switched.
Optional Operations
Making cross-point settings
Cross-point assign tables can be set not only for main output but also for sub
output.
You can set cross-point assign tables for the following banks.
M/E-1 SUB to M/E-4 SUB
P/P SUB
The table actually used is that for which the control panel delegation button is
lit.
To Next Page
Loading...
