Chapter 23 Setup Relating to Router Interface and Tally (Router/Tally)
1109
Tally Generation Settings (Tally Enable Menu)
Disable: Never generate a tally.
Tally Input: Generate a tally from the tally input state.
4
When you selected Tally Input as the tally generation mode in step 3,
select either of the following in the <Tally Input> group.
DCU1: Generate tally with reference to signal input to DCU1 port. Set the
port number with the knob.
DCU2: Generate tally with reference to signal input to DCU2 port. Set the
port number with the knob.
5
Turn the knob to select the tally input port number.
6
Press [Execute].
This sets the settings made in steps 2 to 5 as the settings for tally
generation.
Modifying Tally Generation
1
In the Router/Tally >Tally Enable menu, press [Modify].
The Modify menu appears.
2
With reference to steps 2 to 5 in the preceding section “Making new tally
generation settings,” change the parameters as required.
3
Press [Execute].
This modifies the tally generation settings.
Deleting Tally Generation Settings
1
Using either of the following methods in the Router/Tally >Tally Enable
menu, select the tally generation entry you want to delete.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
2
Press [Delete].
Knob Parameter Adjustment Setting values
5 Input No Tally input port number 1 to 102
To Next Page
Loading...
