Chapter 10 Special Functions
394
Side Flags
1
In the M/E-1 bank cross-point control block, hold down the [UTIL] button,
and in the background A row select the signal (utility bus 1 signal) you
want to insert in the side flag areas.
2
In the background B row, press the cross-point button corresponding to the
4:3 video material.
At this point, if auto side flags are on, this automatically adds side flags to
the 4:3 video material. (See “Settings for Switcher Configuration (Config
Menu)” in Chapter 20 (Volume 3).)
3
Use either of the following methods to turn the side flags on.
• Use the Misc >Enable >Side Flags menu. (See page 392)
• Use a cross-point button operation. (See previous item.)
This adds side flags to the 4:3 video material.
Wipe Action on Images With Side Flags
When a wipe is carried out on an image with side flags, all wipe patterns can
be used.
The following illustration shows the action in a wipe.
Wipe from a 4:3 image to a 16:9 image
Side flag areas
4:3 image (Side flags on)
16:9 image
To Next Page
Loading...
