Chapter 19 Control Panel Setup (Panel)
978
Auxiliary Bus Control Block Settings (Aux Assign Menu)
Auxiliary Bus Control Block Settings (Aux
Assign Menu)
To carry out the settings of the AUX delegation buttons in the auxiliary bus
control block, use the Panel >Aux Assign menu.
To display the Aux Assign menu
In the Engineering Setup menu, select VF2 ‘Panel’ and HF3 ‘Aux Assign.’
The left side of the status area shows the delegation numbers, and the list of
buses set; the right side shows a list of buses that can be assigned.
The following functions are available here.
• Aux Assign: Assign the AUX delegation buttons in the auxiliary bus control
block to any bus.
• Shift Mode: Specify whether the rightmost button of the AUX delegation
buttons is used as a shift button, and when it is used as a shift button, the
operation mode.
Assigning a Bus to an AUX Delegation Button
1
In the Panel >Aux Assign menu, using any of the following methods,
select the delegation button and the bus to be assigned.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
a) The setting can be from 1 to 20. The valid settings, however, depend on the number of
buttons and the delegation button shift mode.
.
b) The buses that can be assigned are as follows.
AUX1 to AUX48, DME1V to DME8V, DME1K to DME8K, and M/E1 Utility1 and 2
P/P Utility1 and 2, Frame Memory Source1 and 2, Edit Preview, DSK1 to 8 Fill/Source,
Knob Parameter Adjustment Setting values
1 Deleg No Selection of AUX delegation
button
1 to 128
a)
2 Bus No Selection of bus to be assigned
1 to 166
b)
Shift mode Valid settings
OFF 1 to 10
ON 1 to 20
To Next Page
Loading...
