Chapter 16 Macros
790
Macro Operations in the Numeric Keypad Control Block and the Keyframe Control Block
Macro Operations in the Numeric Keypad
Control Block and the Keyframe Control
Block
This section describes macro operations carried out in the numeric keypad
control block and the keyframe control block.
Notes
For a macro take operation (see “Macro Execution” (page 788)), do not use
the numeric keypad control block or keyframe control block. Operate with the
take assigned to a utility/shotbox control block or user preference button. (See
“Setting Button Assignments (Prefs/Utility Menu)” in Chapter 19 (Volume 3).)
For an overview of macros, see “Macros” (page 784).
For macro operations in the numeric keypad control block, use the following
buttons. (See the figure on next page.)
To Next Page
Loading...
