Sony MVS-8000X System - Executing a Macro by Macro Attachment

Chapter 16 Macros
819
Macro Attachment Assigning
For details of the macro modes, see “Setting a macro attachment to a button”
(page 813).
For details of the macro attachment list display, see “About the Macro
Attachment List Display” (page 890) in the Appendix.
Moving quickly within the macro attachment list from one block
to another
When you are viewing the macro attachment settings for a block in the macro
attachment list, you can move quickly from the current block to another block
to check the settings for that block by pressing the following buttons in the
<Block Select> group.
• P/P: Move to a block in the PGM/PST bank.
• M/E-1: Move to a block in the M/E-1 bank.
• M/E-2: Move to a block in the M/E-2 bank.
• M/E-3: Move to a block in the M/E-3 bank.
• M/E-4: Move to a block in the M/E-4 bank.
• Aux: Move to a section in the auxiliary bus control block.
• Others: Move to a block/section in a location other than the PGM/PST bank,
M/E-1 to M/E-4 banks, and the auxiliary bus control block.
Scrolling the list
To scroll the macro attachment list, do one of the following.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Executing a Macro by Macro Attachment
Notes
To carry out this operation, it is first necessary to assign the “MCRO ATTCH
ENBL” function to the user preference buttons in the menu control block or the
utility/shotbox control block. Carry out this assignment in the Eng Setup
>Panel >Prefs/Utility menu. (For details, see “Setting Button Assignments
(Prefs/Utility Menu)” in Chapter 19 (Volume 3).)
Knob Parameter Adjustment Setting values
1 No Macro attachment settings scrolling 1 and upwards