Chapter 9 Color Corrector
372
Preparations
Preparations
The color corrector enables video signal color correction (black balance/white
balance adjustment, gamma correction, knee correction, etc.).
Notes
To use the color corrector, the BZS-8420X Color Corrector Software. To use
the software, you are required to input an install key.
For the method of inputting an install key, see “Installation and Device Setup
(Install/Unit Config Menu)” in Chapter 18 (Volume 3).
Assigning the color corrector input buses to AUX delegation
buttons
There are two inputs for capturing material to the color corrector: the CCR1
bus and the CCR2 bus.
For details of the input assignment operation, see “Auxiliary Bus Control
Block Settings (Aux Assign Menu)” in Chapter 19 (Volume 3).
Selecting the color correction input signal
After assigning CCR1 and CCR2 to AUX buses, use the following procedure.
1
Press the AUX delegation buttons assigned to CCR1 (or CCR2).
2
In the cross-point button row, select the signal to which you want to apply
color correction.
Notes
The signals that can be selected on the CCR1 and CCR2 buses are primary
inputs, premium inputs, format converter inputs and frame memory
outputs (FM1 to FM8) only.
However you can make all the internal signals of the switcher selectable
by a setting in the Setup menu.
For details, see “Selecting the Bank to Make the Settings” in Chapter 20
(Volume 3).
To Next Page
Loading...
