Chapter 7 Frame Memory
317
Still Image Operations
Recalling a Continuous Sequence of Still Images
(Animation)
You can use a continuous sequence of images captured with the record function
as keyframes to create an effect. By executing this effect you can recall the
continuous sequence (animation).
Notes
• For example, to create an effect using FM1, FM1 must be assigned to a user
region.
• To execute the effect, you must assign the user region to which FM1 is
assigned to a region selection button in the numeric keypad control block.
(For details of assigning to region selection buttons, see Chapter 19
“Control Panel Setup (Panel)” (Volume 3).)
In the Frame Memory menu, effect creation follows the image file names. Of
the eight characters in the file names, if files have the same characters except
for the last three characters they are treated as an image file group, and the
effect is created with the last three (numeric) characters in sequence.
Notes
When creating the effect in pair mode (see page 299), the files used must be
main files and sub files with the same last three (numeric) characters in the file
name.
To recall a continuous sequence of still images, create an effect in the user
region with the still image files as a keyframe, and run the created effect.
Notes
With the 720P format or 1080P format, you can continuously recall images
using the frame memory in units of two frames only.
Creating an effect with still image files as a keyframe
1
In the Frame Memory menu, select VF1 ‘Still’ and HF5 ‘Create Key
Frame.’
The Create Key Frame menu appears.
• A thumbnail appears for each group of files having the same characters,
except for the last three characters, in the file name.
• When [Pair] is on, only pair files (each pair comprising a main file and
a sub file) appear.
• When [Pair] is off, both single files and pair files all appear.
To Next Page
Loading...
Need help?
General
