Chapter 19 Control Panel Setup (Panel)
942
Overall Control Panel Settings (Config Menu)
Overall Control Panel Settings (Config
Menu)
To carry out the overall control panel settings, use the Panel >Config menu.
To display the Config menu
In the Engineering Setup menu, select VF2 ‘Panel’ and HF1 ‘Config.’
The status area shows the “Bank numbers 1 to 4” (physical locations) of the M/
E and PGM/PST banks, the allocated bank names, and whether or not operation
is enabled.
Panel Setup
In panel setup, you carry out settings particular to the control panel.
You can make the following settings.
Panel settings (Config)
• M/E Assign: Set the logical configuration of the M/E and PGM/PST banks.
• M/E Operation: For each of the M/E and PGM/PST banks, make operations
possible, not possible, or disabled (Enable/Disable/Inhibit).
• Dual M/E Assign: Using two M/E banks, assign the shift and non-shift
button rows of a single M/E bank.
• Dual M/E Xpt Swap: When a setting has been made for Dual M/E Assign,
swap the shift and non-shift button rows.
• DSK Fader Assign: Carry out fader function assignment and key delegation
for the key delegation buttons, in each of the maximum of four downstream
key control blocks.
• External Bus Link: Make link settings relating internal switcher buses to
routing switcher destinations.
• Key Trans Link: Select whether or not to link transitions between keyers,
and if so which keyer to link to. You can set the links between keyers for each
M/E bank separately.
• Joystick/Trackball User Setting: When a trackball module and a joystick
module are both connected as device control blocks, select which is used as
the reference. Also select whether key wipe positioning applies to keys 1 to
8, or to keys 1 to 4.
• 10 Key Region Assign: Assign any regions to the region selection buttons
in the numeric keypad control block. Also used for setting the regions
included in the selection when the [All] button is pressed.
To Next Page
Loading...
