Chapter 20 Switcher Setup (Switcher)
1030
Signal Input Settings (Input Menu)
Selecting the Format Converter Conversion
Selecting the format converter inputs to be set (inputs 1 to 8 or
inputs 9 to 16)
1
Display the Switcher >Input >FC Adjust menu.
Notes
When the conversion format and system signal format are the same, this
operation is not possible.
The following figure illustrates the case when FC Input 1-8 are set to up-
conversion, and FC Input 9-16 are set to cross-conversion.
2
Press [FC Input 1-8] or [FC Input 9-16] as required.
3
Using any of the following methods, select what the setting applies to.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
Button to switch between displaying FC Input 1-8
and FC Input 9-16
a)
a) If FC Input 1-8 and FC Input 9-16 have the same format, this does not appear.
To Next Page
Loading...
