Sony MVS-8000X System - Border Settings

Chapter 11 DME Operations
507
DME Special Effect Operations
Border Settings
Adding a border
1 In the DME menu, select VF1 ‘Edge’ and HF1 ‘Border/Crop.’
The Border/Crop menu appears.
2 Press [Border], turning it on.
The Border effect is enabled. You can adjust the border width parameters
with the knobs.
3 Set the parameters.
The valid ranges of the parameter values depend on the combination of
signal format (SD/HD) and aspect ratio (4:3/16:9) selected in the system,
as follows.
•4:3 mode
Parameter group [1/2]
Knob Parameter Adjustment Setting values
1 H Border width on left and right
sides
Left value shown
2 V Border width on top and bottom
sides
Top value shown
3 All Border width on all sides Left value shown
5 Density Border density 0.00 to 100.00
Parameter group [2/2]
Knob Parameter Adjustment Setting values
1 Top Border width on top side –6.00 to +6.00 (SD)
–18.00 to +18.00 (HD)
2 Left Border width on left side –8.00 to +8.00 (SD)
–24.00 to +24.00 (HD)
3 Right Border width on right side –8.00 to +8.00 (SD)
–24.00 to +24.00 (HD)
4 Bottom Border width on bottom side –6.00 to +6.00 (SD)
–18.00 to +18.00 (HD)
5 Density Border density 0.00 to 100.00