Chapter 17 Files
856
Operations on Individual Files
Deleting frame memory files
Between steps 2 and 3 of the procedure above, “Deleting Files,” do as follows.
Notes
• In a still image file saved in the 1080P signal format, there are two still image
files for each frame. When a register is selected for the operation, if you
delete one still image file, the other file of the pair is automatically deleted.
• When a device other than a register is selected for the operation, if you delete
one still image file, the other file of the pair is not automatically deleted. You
must manually delete both files.
1
To select the frame memory folder, press [Default] in the device selection
in the list.
A pull-down menu appears.
2
Press the required folder name.
3
Select the type of data to be displayed.
• To display still image files, press [Still].
• To display clip files, press [Clip].
• To display extended clip files, press [Ext Clip].
• To display all types of file, press [All].
Converting Between Frame Memory Clips and
Extended Clips
Notes
When the signal format is 1080P, this operation is not possible.
1
In the File menu, select VF5 ‘Frame Mem’ and HF1 ‘Frame Memory.’
The Frame Memory menu appears. The status area shows the device status
and a list of files on the device.
2
Press [File Edit].
3
In the device selection section of the list, select where the file is held
([HDD] or [Memory Card]), and specify the directory, and frame memory
folder.
To Next Page
Loading...
