Chapter 11 DME Operations
536
DME Special Effect Operations
The Defocus effect is enabled. You can adjust the defocusing of video and
key signals with the knobs.
Notes
On the MVE-8000A, the Defocus and Glow effects cannot be enabled at
the same time. The effect which was turned on most recently is enabled.
3
In the <Defocus Mode> group, select the signal to which to apply the
defocus effect.
Video/Key: Video signal and key signal
Video: Video signal only
4
Set the parameters.
• When Video/Key is selected
• When Video is selected
.
5
To cancel black level leaking that can occur at the edge of the screen when
the Defocus effect is enabled, press [Clean Defocus], turning it on.
Masking the Defocus effect with a selected pattern
Press [Mask] to display the Mask menu, and set the pattern type and modifiers.
For details, see “Mask Settings” (page 548).
Knob Parameter Adjustment Setting values
1 H Horizontal defocusing of video
and key signals
0.00 to 100.00
2 V Vertical defocusing of video and
key signals
0.00 to 100.00
3 All Horizontal and vertical
defocusing of video and key
signals
H value shown
Knob Parameter Adjustment Setting values
1 H Horizontal defocusing of video
signal
0.00 to 100.00
2 V Vertical defocusing of video
signal
0.00 to 100.00
3 All Horizontal and vertical
defocusing of video signal
H value shown
To Next Page
Loading...
