Chapter 20 Switcher Setup (Switcher)
1022
Settings for Switcher Configuration (Config Menu)
Notes
When Multi Program mode is selected, two or more transition type indication
may light. It is also possible that more than one “Transition Type” has been
selected in the Misc >Transition menu for each M/E.
Assigning the output of each bank in Multi Program mode
When you selected [Multi Program] as the operation mode, use the following
procedure.
1
In the Switcher >Config menu, press [M/E Output Assign].
The M/E Output Assign menu appears.
2
On the list in the status area, select the bank output to be assigned.
The selected output appears in reverse video.
3
In the <M/E Output Assign> group, select the output signal to be assigned.
Setting the output configuration for each bank
When you selected [Multi Program] or [DSK] as the operation mode, use the
following procedure.
1
In the Switcher >Config menu, press [PGM Config].
The PGM Config menu appears.
The status area shows the background and key configuration assigned to
the output of each bank.
2
Using either of the following methods, select the output for which you
want to make the setting.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
The selected output appears in reverse video.
3
In the <Bkgd> group, select the background.
In Multi Program mode, select [Clean] or [Utility2], then skip to step 5.
In DSK mode, select one of [Bkgd1] to [Bkgd4].
Knob Parameter Adjustment Setting values
1 No (PGM) Output to which setting applies 1 to 20
To Next Page
Loading...
