Chapter 20 Switcher Setup (Switcher)
1055
Settings Relating to Function Links (Link Menu)
7
In the <Bus> group, select any of the following.
Enable: Enable the GPI link setting for the selected bus.
Disable: Disable the GPI link setting for the selected bus.
All Enable: Enable the GPI link setting for all buses.
Setting the delay value
1
In the Switcher >Link >GPI Link Adjust menu, turn the knobs to select the
output port for which you want to set the delay value, and the
corresponding delay value.
2
Press [Delay Set].
This confirms the delay value, which is reflected in the status area.
Setting the Re-entry Button Operation Mode
When you select a re-entry button in the cross-point control block of an M/E
block (downstream M/E block), the output of the upstream M/E block is read
in. You can set the system so that when a GPI link is set for the cross-point
selected on the A
a)
bus of the upstream M/E block this triggers the GPI output.
In the Switcher >Link >GPI Link menu, set [Re-Entry Enable] to On or Off.
When this is On, the GPI is executed upstream.
a) When the bus toggle is set to Off, the applicable bus depends on the position of the fader lever.
Notes
• For re-entry, “upstream” applies to a single stage only.
• This setting is common to all GPI output ports.
• GPI output execution on the upstream M/E block is only possible on buses
for which GPI Link is set to “Enable” in the GPI Link Adjust menu.
• GPI output occurs when you press a re-entry button, the re-entry button is
selected by a macro execution, or you press the re-entry button on the AUX
bus remote panel.
Knob Parameter Adjustment Setting values
4 Bus Bus selection 1 and upwards
Knob Parameter Adjustment Setting values
1 GPI Port GPI output port for the
setting
1 to 8
5 Delay Delay value for the output
port
0 to 300 (fields)
To Next Page
Loading...
