Appendix (Volume 3)
1144
Error Messages
Extraction Clip register error (–14). 2542:Frame Memory >File >Auto Extraction
In the above menu, when [Extraction Start] is
pressed, this message appears if the specified
register number data cannot be processed
(internal processing error).
Can’t extract pair clip (–15). 2542:Frame Memory >File >Auto Extraction
In the above menu, when [Extraction Start] is
pressed, this message appears if an attempt is
made to extract a pair clip.
Clip id not enough (–50). 2542:Frame Memory >File >Auto Extraction
In the above menu, when [Extraction Start] is
pressed, this message appears if there are 100
clips or more.
Still frame on FM 2nd board (–
51).
2542:Frame Memory >File >Auto Extraction
In the above menu, when [Extraction Start] is
pressed, this message appears if a still image
was extracted from an external clip.
Clip frame number can’t be
ODD in 720P format (–9).
2542:Frame Memory >File >Auto Extraction
In the above menu, when [Extraction Start] is
pressed, this message appears if an odd
number of clips are extracted (720P format
only).
File Frame
Memory
Some requests are skipped.
Following operation is not
permitted.
— Loading that will cause
duplicate register name.
7151: File >Frame Memory
7162: File >All, External File >Import/Export
In the above menu, an attempt was made to
load a file of a name already existing in the
register.
File Open
Status
ERROR (01) 533X: Device >DDR/VTR
When an error is returned from the DDR/VTR,
one of these messages appears, depending on
the error number.
Use Menu 7355: Engineering Setup >DCU
>Serial Port/MPE Assign or Menu 7325.4:
Engineering Setup >Panel >Device Interface
>Serial Port Assign to check the device
settings.
ERROR (02)
ERROR (FF): No target device
has been assigned
GPI Input Please set Target. 7325.1/2: Engineering Setup >Panel >Device
Interface >GPI Input
7344.1/2: Engineering Setup >DME >Device
Interface >DME1 GPI Input
7344.5/6: Engineering Setup >DME >Device
Interface >DME2 GPI Input
7352/7352.1: Engineering Setup >DCU >GPI
Input Assign
In the above menus, when making a setting, a
parameter setting value was incorrect. Check
the settings, and try again.
Please set Trigger Type.
Please set Reg No.
Please set Aux Bus No.
Please set Src No.
Please set Pulse Width.
Please set Pulse Timing.
Icon Title Message Description
To Next Page
Loading...
