Chapter 4 Keys
159
Overview
Edge type and key fill/key source position
The key edge modification function has two modes: a mode (“key drop ON
mode”) in which the key fill/key source position moves downward, and a mode
(“key drop OFF mode”) in which it does not move downward.
Drop
border
This applies a border below and to the right
for example, of the key. You can adjust the
border width, position, and density.
Shadow This applies a shadow below and to the right
for example, of the key. You can adjust the
shadow width, position, and density.
Outline This uses the outline of the original key as
the key. You can adjust the width and density
of the outline. You can also enable the
separate edge function, and adjust the top,
bottom, left, and right outline widths
separately.
Emboss This applies an embossing effect to the
outline of the key. You can adjust the width
and position of the embossing, and the
density. You can adjust the density
separately for key fill and key edge. When
embossing is on, the Fine Key and zabton
functions go off.
–
Soft
edge
This softens the edge of the key. –
Zabton This inserts a translucent pattern behind a
key. You can adjust the pattern size,
softness, density and color.
–
Name Effect Image
To Next Page
Loading...
