Chapter 4 Keys
195
Key Setting Operations With the Cross-Point Control Block
Notes
When the signal format is 1080P, the combination of two consecutively
numbered DME channels that can be selected is DME1 and DME2, DME3
and DME4, DME5 and DME6, or DME7 and DME8. It is not possible to
combine three or more DME channels.
• On keys 1 to 4 of one M/E, a maximum of two DME effects (including DME
wipes) can be used simultaneously. However, when using a DME wipe
pattern for the background, the restriction depends on the execution mode as
follows.
One-channel mode: DME can only be used in one place on keys 1 to 4.
Two-channel mode or three-channel mode: DME cannot be used for keys 1
to 4.
• When the system signal format is 1080P, and the DME input/output signal
format is set to dual link mode, the following restrictions apply.
– On keys 1 to 4 of one M/E, a maximum of one DME effect (including
DME wipes) can be used simultaneously.
– When a DME wipe pattern is selected for the background, DME cannot be
used for keys 1 to 4.
• On keys 5 to 8 of one M/E, a maximum of two DME effects (including DME
wipes) can be used simultaneously. However, for keys 5 to 8 of the M/E4
block, DME effects cannot be used.
• For keys 5 to 8 on the M/E4 bank, DME effects cannot be applied.
Ending a DME assignment
As an example, to end the assignment of a DME to key 1, in the cross-point
control block, hold down the key row delegation button [KEY1] and press the
DME button ([DME1] to [DME4]) that is lit green.
The button goes off, and this ends the assignment.
Selecting the video signal for a DME assigned to a key
1
In the cross-point control block, press the key row delegation button
[KEY1].
The assigned DME button lights amber.
2
Press the DME button (one of [DME1] to [DME4]) lit amber, which then
lights green.
3
To select the video signal for the side of the DME image that is currently
visible, make the signal selection in the key row.
4
To select the video signal for the side of the DME image that is currently
not visible (the back side), hold down the DME button (one of [DME1] to
[DME4]) and make the signal selection in the key row.
To Next Page
Loading...
