Chapter 5 Wipes
252
Basic Procedure for Wipe Settings
The Main Modify menu appears.
2
Press [Spring], turning it on.
3
Set the following parameters.
Applying a spiral effect to the wipe pattern (Spiral)
This deforms the pattern spirally.
• The parameter Magnitude determines the size and direction of the spiral.
A value of –100.00 represents the maximum movement in the
counterclockwise direction, and a value of +100.00 represents the maximum
movement in the clockwise direction.
• The parameter Wave Speed determines the speed of the lateral waves.
A value of –100.00 represents the maximum speed to the left, and a value of
+100.00 represents the maximum speed to the right.
You can set the spiral function independently for the main and sub patterns.
1
In the M/E-1 >Wipe menu, select HF5 ‘Main Modify.’
The Main Modify menu appears.
2
Press [Spiral], turning it on.
3
Set the following parameters.
Knob Parameter Adjustment Setting values
1 Gain Degree of barrel distortion –100.00 to +100.00
Spiral off
Spiral on
Knob Parameter Adjustment Setting values
1 Magnitude Size and direction of the spiral –100.00 to +100.00
2 Wave Speed Speed of the lateral waves –100.00 to +100.00
To Next Page
Loading...
