Chapter 6 DME Wipes
281
Basic Procedure for DME Wipe Settings
Display indications when multiple channels are selected at the same
time
The indications on the knobs show the settings of the lowest-numbered
channel. When you turn the knobs to adjust the settings, this changes the
settings on the other channels by the same amount.
In 16:9 mode, to crop to 4:3 aspect ratio
In the <Crop Mode> group, press [4:3 Crop], turning it on.
To set the action when a DME wipe crop transition is executed
1
In the M/E-1 >DME Wipe menu, select HF5 ‘Modify.’
The Modify menu appears.
2
Depending on whether the selected pattern is in one-channel mode or two-
channel mode, proceed as follows.
For a pattern in one-channel mode: in the <Ch Select> group, press [1st
Ch], turning it on.
For a pattern in two-channel mode: from the <Ch Select> group, select
the corresponding channels. You can select more than one channel at
the same time.
3
In the <Crop Mode> group, press [Crop] or [4:3 Crop] (to crop from 16:9
to 4:3 aspect ratio), turning it on.
4
In the <Crop Mode> group, press [Remove From Begin].
Parameter group [1/2]
Knob Parameter Adjustment Setting values
1 H Crop the left and right of the
image
Left value shown
2 V Crop the top and bottom of the
image
Top value shown
3 All Crop the top, bottom, left, and
right of the image
Left value shown
Parameter group [2/2]
Knob Parameter Adjustment Setting values
1 Top Crop the top of the image –100.00 to +100.00
2 Left Crop the left of the image –100.00 to +100.00
3 Right Crop the right of the image –100.00 to +100.00
4 Bottom Crop the bottom of the image –100.00 to +100.00
To Next Page
Loading...
