Sony MVS-8000X System - Page 544

Chapter 11 DME Operations
544
DME Special Effect Operations
b) The larger the Clip value, the narrower the outline width.
• When Relief is selected
a) 100.00 gives an image completely transformed by the Sketch effect. 0.00 is the original
input image.
• When Sharp is selected
5 If you selected other than Sharp in step 3, depending on the necessity,
proceed as follows.
• To adjust the outline color for Edge Color or Draw
Turn [Edge Matte] on and set the following parameters to set the outline
color.
• To set the color of the sections other than the outlines for Draw
Press [Matte], turning it on, and adjust the following parameters to set the
color of the sections other than the outlines.
Knob Parameter Adjustment Setting values
1 Mix Mix amount for Relief video and
input video
0.00 to 100.00
a)
2 Offset Relief luminance level –100.00 to +100.00
3 Gain Image gain for outline extraction –100.00 to +100.00
4 Angle Direction of relief image light
source
–8.00 to +8.00
Knob Parameter Adjustment Setting values
1 H Simultaneously adjust the left and
right resolution
0.00 to 100.00
2 V Simultaneously adjust the top and
bottom resolution
0.00 to 100.00
3 All Simultaneously adjust the
resolution of all four sides
0.00 to 100.00
5 Coring Minimum value of edge to
emphasize
0.00 to 100.00
Knob Parameter Adjustment Setting values
1 Luminance Luminance 0.00 to 100.00
2 Saturation Saturation 0.00 to 100.00
3 Hue Hue 359.99 to 0.00
Knob Parameter Adjustment Setting values
1 Luminance Luminance 0.00 to 100.00
2 Saturation Saturation 0.00 to 100.00
3 Hue Hue 359.99 to 0.00