Chapter 11 DME Operations
575
DME Special Effect Operations
Page Turn settings
There are four modes: H&V, H, V, and Off. You can select the turn position,
the radius of the turned portion, the amount and angle of turning, and the input
video for the front and back pages.
To apply the Page Turn effect
With the Page Turn menu displayed, use the following procedure.
1
In the <Split Mode> group, select the split mode.
H&V: The image turns as it is split from the center into 4 parts: left, right,
upper, lower.
H: The image turns as it is split from the center into 2 parts: left, right.
V: The image turns as it is split from the center into 2 parts: upper, lower.
When nothing is selected (Off): There are no splits and the image turns
from the edge.
2
Press [Page Turn], then set the following parameters.
a) When split mode is H&V
b) When split mode is H
c) When split mode is V
d) When split mode is off
To set the input signal of the back page
1
In the <Back Video> group, select the signal input into the back page.
Self: Use the same signal as the front page.
Flat: Use a flat color.
Hue Rotation: Gradually vary the hue.
2nd Ch: Use the 2nd channel video signal.
To select “2nd Ch,” it is first necessary to select the second DME on
the keyer using DME.
2
Adjust the following parameters, according to the selected input signal.
Knob Parameter Adjustment Setting values
1 Radius Radius of turn part 0.00 to 100.00
2 Offset Amount of turn –100.00 to +100.00
3 Angle Angle of turn
–0.250 to +0.000
a)
–0.250 to +0.250
b)
–0.500 to +0.000
c)
–8.000 to +8.000
d)
To Next Page
Loading...
