Chapter 12 External Devices
672
Control of VTRs, Extended VTRs, and Disk Recorders
3
To set the name of a file when using an Extended VTR or disk recorder,
recall the file using the Device >DDR/VTR >File List menu.
Notes
• There is a limit of eight disk recorder files that can set on a single
timeline.
• If you have not set the file name when using an Extended VTR, the file
recalled in the Extended VTR when the keyframe point is passed is the
subject of the action.
For details of settings required to recall a file, see “Sharing Disk
Recorder/Extended VTR File Lists” in Chapter 19 (Volume 3).
When not using an Extended VTR or disk recorder, or when the file name
has not been set for an Extended VTR, skip to step 4.
4
In the <Action> group, select the action.
Cueup: Output a command to cue up to the currently displayed start point.
Start: Output a Play command.
Notes
When the stop point and variable speed are both set, the variable speed
setting takes priority.
Stop: Output a Stop command.
Notes
Before executing the Stop command, if the timecode for the set stop
point has been reached, or on an Extended VTR or disk recorder if the
end of the file has been reached, then at that point the device stops.
5
To set a start point, in the <Start TC> group, press the [Set] button.
A timecode window appears.
If you do not want to set the start point, skip to step 8.
Notes
For a disk recorder on which the start point is not set, the file recalled in
the disk recorder when the keyframe point is passed is the subject of the
action.
Knob Parameter Setting Setting values
1 Dev Device number 1 to 12
To Next Page
Loading...
