Chapter 2 Menus and Control Panel
75
Names and Functions of Parts of the Control Panel
a Timecode display
This shows the current time (CURRENT)
and the start and stop point timecode values
for the current reference device (START
TC, STOP TC). When you press a device
selection button, the button lights, selecting
the assigned device as the reference device,
and displaying its setting value.
In the case of the [SBOX] buttons, the
display does not change. The displayed
setting value depends on whether the
[TIMELINE] button is on or off, as follows.
When the [TIMELINE] button is on:
Displays the start and stop points of the
last set keyframe on the timeline. When
the keyframe number is changed and
the last register and keyframe change,
the display also changes. (timeline
setting mode)
When the [TIMELINE] button is off:
Displays the Cueup & Play (rewind
action) start and stop points.
b Device selection buttons
These buttons are used for selecting
assigned external devices or frame memory
clips.
Each button can only be assigned to a single
device. Carry out the assignment in the
Setup menu (see “Overall Control Panel
Settings (Config Menu)” in Chapter 19
(Volume 3)). To select an assigned device,
press the corresponding button, which
lights green. To select more than one device
simultaneously, hold down the button for
the first selection, while pressing the
buttons for the other selections in turn. The
second and subsequent selected buttons
light amber. If you press another button
without holding down the first selected
1 Timecode display
2 Device selection buttons
4 DELAY button
5 Editing
buttons
6 External device
operation buttons
7 TIMELINE button
8 STOP button
9 Search dial
3 SBOX buttons
To Next Page
Loading...
