Chapter 16 Macros
796
Macro Operations in the Numeric Keypad Control Block and the Keyframe Control Block
This assigns the numeric keypad control block and keyframe control block
to macro editing, and the [MCRO] button in the numeric keypad control
block and the [EDIT ENBL] button in the keyframe control block light red.
The [STORE] button in the numeric keypad control block flashes red.
3
Using any of the following methods, specify the edit point.
• To move the edit point to the event immediately following the current
macro event, press the [NEXT KF] button in the keyframe control block.
• To move the edit point to the event immediately preceding the current
macro event, press the [PREV KF] button in the keyframe control block.
• To move to an edit point by specifying an event number (the number
showing the position of the event in the macro execution sequence),
press the [GO TO KF] button in the keyframe control block, then in the
numeric keypad control block, enter the target number and confirm with
the [ENTER] button.
Inserting an event
1
Specify the edit point. (See page 795.)
2
If required, press the [AUTO INS] button assigned to a utility/shotbox
control block or user preference button, to toggle the auto insert mode on
or off.
3
Create the event.
• When auto insert mode (see page 794) is on, the event is automatically
added to the macro.
• When auto insert mode is off, proceed to step 4.
4
When auto insert mode is off, press the [INS] button in the keyframe
control block.
5
Repeat steps 2 and 3 to insert the required events in the macro.
Modifying a single event
1
Specify the edit point. (See page 795.)
2
When the [AUTO INS] button assigned to a utility/shotbox control block
button or user preference button is lit, press this to turn the auto insert mode
off.
3
Create the event.
To Next Page
Loading...
