Chapter 16 Macros
814
Macro Attachment Assigning
a) In the case of an event that inserts or deletes a key by an independent key transition, the key state
at the time of event registration (inserted or not inserted) is also saved in the macro. When the
macro is executed, the event is only replayed if the key state matches the saved state. (Example:
For a macro with an event that deletes a key, when the macro is executed, if the key is inserted
it is deleted, but otherwise nothing occurs as concerns keying.)
b) KEY5 to KEY8 and DSK5 to DSK8 require an assignment.
c) Assignment is required
Notes
• After setting a macro attachment to a cross-point button of the bus assigned
by AUX delegation setting, if in the Setup menu you change the bus
assignment to the button, the macro attachment setting disappears.
• After setting a macro attachment to a button for which you can perform
function replacement or function assignment, if you change the function
assignment to the button, the macro attachment setting disappears.
• After setting a macro attachment to a cross-point button in the cross-point
control block, if you change the function assignment to the button, the macro
attachment setting disappears.
Enabling and disabling macro attachment
You can temporarily disable the macro attachment settings. When a macro
attachment is disabled, pressing the button does not cause execution of the
assigned macro.
You can enable or disable macro attachments for the individual control panels.
Assign the function to enable or disable macro attachments to a button in the
utility/shotbox control block or a user preference button, and turn the button on
and off as required.
Setting a macro attachment to a fader lever
You can set a macro attachment to any particular position of a fader lever in the
transition control block.
Notes
• In macro-only mode it is not possible to set a macro attachment.
Downstream key control block • [DSK1 ON] to [DSK8 ON] buttons
a) b)
• [KEY1 ON] to [KEY8 ON] buttons
a) c)
• [TAKE] button
a)
• [MIX], [WIPE], [DME], and [CUT] buttons
Transition control block All buttons except [PRIOR SET], [TRANS PVW],
[SHIFT], [ADD], [KF], [MAIN], [SUB], [LIMIT SET],
[K-SS], and [K-SS STORE] buttons
Utility/shotbox control block Memory recall buttons
Menu control block [PREFS 1] to [PREFS 16] buttons
Block Button
To Next Page
Loading...
